![]() ![]() I was just looking at the ebay picture of the board and thinking about the way I have it mounted now. I moved it to off because I am using 8-way joysticks. These were the settings it had when I first got the board, with the exception of U12 SW3. The LED stays at 8 with or without the hard drive plugged in, and the hard drive does not spin up if the IDE cable is plugged in.ĭipswitches U12 SW1 and SW4 are on, the rest of U12 and all of U13 are off. I got it off of ebay and it had no description or documentation. I really don't know if it's a conversion kit or not. ![]() I am positive I saw a 0 at one point after it had sat for a while, but I was changing jumper settings and dip switches quite a bit at the time so I can't remember what the circumstances were. It starts out at 8 and just stays there indefinitely. I'm new to this so I'm just sort of fumbling through it. The LED that should go through the start sequence shows an 8, and once had a 0.Īny help would be greatly appreciated. I think I have the same symptoms as this thread. I have the jamma harness, player 3 and player 4 connectors currently hooked up, and the coin door, gun 1 and gun 2 connectors not hooked up. It has the original monitors (A48ABK05X) that I believe are K7000's, and one is not in use at the moment (that's a whole other issue). Some background on my setup is that I'm using it in a Cyberball cabinet that is running a midway board with NBA Hangtime. LED8 (Audio Activity) is solid yellow, indicating "Locked up". According to the manual that means "S I/O Board locked up".ģ. Off means "not in use", solid green means "Locked up".Ģ. The hard drive LED (LED2 on CPU board) is off, but if I unplug the drive the light is solid green. When I power it up, according to the LED's, the power is OK on all boards. I have the GDL boards and hard drive that shows version 2.4 on a sticker. Hey everyone, this is my first repair question so hopefully I get this right. ![]()
0 Comments
Leave a Reply. |